FAQs

• Problems & Solutions: Relearn Procedure

  Problem description 1:

   

  I cannot complete the sensor relearn.

   

  Solution:

   

  Please carefully follow the step-by-step instructions displayed under Relearn Procedure on your Autel tool.  

   

  Problem description 2:

   

  I performed auto relearn and drove the vehicle, but was unsuccessful in relearning IDs.

   

  Solution:

   

  Drive the vehicle consistently at the speed of between 25 km/h and 100 km/h (15 mph and 62 mph) throughout the Relearn process.

  Wait at least 15 minutes before starting a second relearn.

• Problems & Solutions: TPMS Parts

  Problem description 1:

   

  The TPMS light is lit on the dash of my 2005 vehicle, what should I do?

   

  Solution:

   

  The tire pressure control module might be faulty. Use an Autel tool with OBDII-connection capability such as the TS508 or TS608 to detect trouble codes within the TPMS module. You may need to repair or replace a part within the system such as a transmitter or receiver.

   

  Problem description 2:

   

  My vehicle had a collision. Now my TPMS light stays on. What do I do?

   

  Solution:

   

  The vehicle may have a damaged TPMS module or non-functioning sensors or both. Use an Autel TPMS tool to check the sensors and the control module.

  If sensors fail to activate, the sensors need to be replaced. Program Autel’s MX-Sensors to replace sensors. Follow the vehicle manufacturer-specific Relearn procedures displayed on your Autel tool. If the sensors fail to relearn, connect the Autel TPMS to the OBDII port to scan for system faults. You may need to repair or replace a part within the system such as a transmitter or receiver.

1 2 3 4 GO